preparations you shall do before using PTFE membrane middle seal welding machine

Views : 3362
Author : indrofiltermachine.com
Update time : 2020-05-12 13:15:23
SIIC-M025-MSW-H from INDRO is using smart welding system to realize the middle seam welding of filter cartridges, special for welding PES, nylon, fiberglass, PTFE membrane pleats. What prepartions you shall do before using this machine?
You shall do following preparation:
1. This equipment is sensitive to the voltage, voltage instability is easy to damage the equipment. Therefore, we recommend that customers before using the machine, equipped with voltage stabilizer. The input voltage of this equipment is 220V, 2 phase, 50hz.
Voltage regulator you required: 3KW, 50hz.
2. Prepare a 3 kg air compressor.
3. Fix the heating belt onto the upper and lower surfaces of the welding molds.
2pcs of heating belts are fixed before shipping from our factory.
Normal heating belt is silver, after a period of use, when the heating belt yellow, the need to replace the new heating belt.
(See the steps below for how to change the heating belt)
4. Stick the mould paper onto the upper and lower surfaces of the welding mould.
Mold papers are already fixed onto moulds before shipping from our factory.
After a period of use, when the mould paper yellow, you need to replace the new mould paper.